Performance Engineering
Tuning Specifications
Stage 1 Through Stage 4
Extracting maximum velocity and quarter-mile acceleration from Leonida exotics requires more than bolt-on cosmetic exhausts. Optimal setups demand precise ECU ignition maps, calibrated gear ratios suited for coastal highway wind resistance, and calculated aerodynamic downforce configurations.
Induction Blueprint
Forced Induction & Turbo Mapping
Calibration Protocol: Boost-99
Replacing standard wastegates with dual pneumatic electronic actuators eliminates pressure spikes during rapid gear shifts. For high-speed expressway runs between Vice Beach and Kelly County, boost curves should be delayed until 3,800 RPM to preserve tire compound adhesion off the line.
Pressure
2.2 BAR
BHP Gain
+240 HP
Torque Apex
820 LB-FT
Chassis Alignment
Track Geometry & Suspension Dampening
Geometry Setup: Circuit G-7
Street pavements across Little Haiti and industrial dock areas feature uneven asphalt seams. Excessively stiff compression dampening leads to chassis skip. Maintain moderate rebound compliance while dialing in -2.5 degrees of negative front camber for apex tracking.
Front Camber
-2.5°
Rear Toe
+0.15°
Ride Height
75 MM
Specialist Tuning Garages
Approved Mechanics
Shop Profile 01
Hao's Special Works (Vice Outpost)
Ocean Drive Industrial Mews
Exclusive access to prototype transmission upgrades, low-friction ceramic differentials, and programmable launch control modules that boost acceleration trap speeds by up to 18%.
Shop Profile 02
Bennie's Original Motor Works
Downtown Rail Spur
Specialists in lowrider hydraulics, retro widebody conversions, and bespoke interior re-trimming using authentic perforated leather, diamond stitching, and mahogany steering bosses.
Shop Profile 03
Kelly County Drag Fabrication
Ambrosia By-Pass Warehouse 4
Specializes in NHRA-grade tubular chromoly roll cages, wheelie bar setups, parachute deceleration packs, and methanol injection systems tailored for straight-line runway dominance.